Full Home Remodeling in Culver City
Raising a Culver City living room ceiling to the roof line starts in the attic, with ceiling joists, beams, insulation depth and duct routes checked first.
Whether the living room ceiling can rise to the roof line is a question that gets answered in the attic on a first Culver City visit. Ceiling joists often tie the walls together against the outward push of the rafters, so removing them can mean a structural ridge beam with posts down to new footings, or ties kept in view. The answer also moves the insulation, wiring and any duct running up there.
What holds the roof now
With a light and a tape, we follow the rafters from the wall to the ridge and note how the ceiling joists meet them. Where joists are nailed to the rafter heels, they keep the walls from spreading, and taking them out needs a replacement. Options include a ridge beam sized by an engineer and carried on posts to new footings, or ties raised higher with calculations to back them. Wiring, ducts and any vent pipe in the attic are mapped on the same visit, since each needs a new route.
Insulating and finishing a vaulted ceiling
A vaulted ceiling puts its insulation between the rafters, so rafter depth decides how much fits and whether a vent space stays above it. Where the depth falls short, rigid foam over the roof deck or furring below the rafters adds room, and energy compliance forms record the result. Recessed lights in a sloped ceiling need housings rated for contact with insulation. The finished ceiling is boarded, taped and painted with the rest of the room, and a ceiling fan helps push warm air back down.
Full Home Remodeling in Culver City: questions to settle first
Demolition opens the ceiling and walls, then the roof framing changes and any beam and footings are built. Plumbing, gas, wiring and ducts are rerouted and inspected, the frame inspection follows, then insulation. Board, tape and paint close the rooms, and floors, cabinets and counters finish the work, with the kitchen's lines placed ahead of the rest.
In many cases. If the wall carries ceiling joists or a beam, an engineer designs its replacement and the Culver City building department reviews it with the permit. Where the ceiling is also being vaulted, the two structural changes are designed together, since both move roof load onto new posts and footings.
Ceiling height and the roof framing plan, which walls move, the kitchen layout and appliance list, window sizes, and where ducts and lights will run once the attic space shrinks. Those decide structure and rough work. Flooring, tile, paint and hardware can be chosen once framing is under way.
Full Home Remodeling in other cities
More work we plan in Culver City
Start your full home remodeling plan in Culver City
Describe the space and the change you want. We reply with what the first visit covers.