Remodeling in Simi Valley, Ventura County
Kitchen Remodeling in Simi Valley
Navon Home runs Simi Valley kitchens the way it runs them in Moorpark, Oak Park and Thousand Oaks: layout drawn first, ember rules checked, finishes last.
Moorpark, Oak Park, Thousand Oaks, Agoura Hills, Westlake Village and West Hills all get the same kitchen sequence from us, and so does Simi Valley. A measured plan fixes the cabinet run and the clearances, the hood route and gas sizing follow, then the panel is checked for new circuits. The steps that change from one city to the next are the office that reviews the permit and whether the lot is on a fire hazard map.
Layout before the order goes in
On the first visit we sketch the room to scale and mark the window, the doors, the drain line and where gas enters. The work triangle and the landing space beside the sink, range and fridge are drawn from that sketch. Next we confirm the hood can reach an outside wall or the roof on a short duct. Cabinets are sized off the approved drawing, and counters are templated after the boxes are set. Paint, tile and pulls are chosen at the end, against a layout that will not move.
Ember rules and the Simi Valley permit
Fire hazard maps take in portions of Simi Valley. For a parcel inside one, changing a kitchen window, wall vent or patch of siding can bring ember-resistant construction into the job. A new window may need two panes of glass, one of them tempered, a hood cap gets a damper and fine metal mesh, and patched siding uses an ignition-resistant material. The Simi Valley building department reviews the drawings and inspects each stage. We confirm the fire map for the exact parcel before the layout is final.
What we plan and build in Simi Valley
Every project here starts the same way: a measured layout, then the lines behind the walls, then finishes.
Planning a kitchen in Simi Valley?
Send a few lines about the room. We reply with the next step for a design visit.