Full Home Remodeling in La Verne
A La Verne whole-house remodel that adds an automatic water shutoff, leak sensors at each wet spot, flashed openings and stucco details that drain.
An automatic shutoff valve on the main water line can close the supply the moment a sensor under a sink or beside the washer feels water, and in a La Verne whole-house remodel it goes in while the walls are open. Outside, the lower edge of new stucco ends at a weep screed set at least 4 inches above the soil so moisture in the wall can drain out. Between them, pipe leaks and rain both stay out of the framing.
Water from inside the house
Sensors go under the kitchen sink, next to the dishwasher, beside the refrigerator supply line and in the laundry, and each one is wired or paired to the valve on the main. Under the washing machine sits a pan with its own drain line. The water heater gets its own pan and a relief line run to where discharge is allowed. New supply lines go in PEX or copper with a stop valve at each fixture, and every joint is pressure tested before drywall covers it.
Water from outside
Each new window or door opening in the exterior is wrapped with flashing tape lapped shingle style so each upper layer sheds over the one below. When stucco is patched, new building paper is lapped into the old, metal lath goes over it, and the city inspects paper and lath together before the plaster coats begin. Downspouts get extensions or splash blocks that carry roof water away from the foundation, and soil that has built up against the wall is pulled back so the screed stays clear.
Full Home Remodeling in La Verne: questions to settle first
Framing changes follow demolition and come before any new pipe or wire. Rough plumbing, gas, electrical and ducts follow, along with the leak sensors and the shutoff valve, and the city inspects them. Exterior patches are sealed next, then insulation and drywall. Cabinets, counters, flooring, tile, trim and paint finish the house.
Yes, if what it holds is accounted for. Should it carry weight, an engineer sizes a beam and the posts and footings under it, and the city reviews that before any cutting. Supply and drain lines inside the wall are rerouted and pressure tested in their new path. A wall holding no weight comes out once those lines and any wiring are moved.
Sink, dishwasher and range positions come first, along with appliance models, since they fix drain, supply and gas routes. Next are which walls move, any new or relocated bathrooms and the laundry spot, because each wet area needs its own leak protection. Window and door sizes matter too, as every new opening has to be flashed. Finish colors can wait.
More work we plan in La Verne
Start your full home remodeling plan in La Verne
Describe the space and the change you want. We reply with what the first visit covers.